Supplies Needed:
|
|
Step One
Starting with 12x12 cardstock – score at 4” from each side, creating 9 four inch squares.
|
|
Step Two
On bottom left square, cut a small slit as shown that ends at the bottom left corner of the middle square. The slit at the widest point is less than 1/8” – so very minimal slant – no specific measurement required. Repeat same slit from the bottom right corner.
|
|
Step Three
Flip cardstock top to bottom and repeat.
|
|
Step Four
Fold sides up with the full, uncut square panels to the outside, creating a clean polished box.
|
|
Step Five
Using 8.5 x 11 Cryogen White, cut a 6x6 square of cardstock – saving left over white to create tag.
|
|
Step Six
Score each of the four edges 15/16” from the edge.
|
Step Seven
Repeat Step 2 - creating slits in the corners.
|
Step Eight
Apply blue ink to Scrapblock ™. Working with the rubber image side up, lay 6x6 cardstock square to stamp. Apply even pressure over cardstock surface to insure even impression.
|
|
TIP
I use an acrylic block to rub over the top of the cardstock to be extra safe.
|
|
Step Nine
Repeat Step 4 with the white stamped sheet to create the lid.
|
|
Step Ten
Using excess white cardstock, stamp Elvis image in blue. Trim with decorative scissor, punch or Nestabilities.
|
|
Details on Tag
Stamp ‘Thank you very much’ sentiment in black ink on lower portion of tag.
Accent lights of Graceland with a touch of white glitter, if desired.
Punch hole in upper left corner of the tag.
|
|
Completed Project
Tie tag onto box and stick with decorative pin.
|
|